CONTACT
  • Address:EuroCMA,Harbor Industrial Park,Shanhaiguan District,Qinghuangdao,China
  • Postcode:066004
  • Call:+86-0335-5035388
  • Fax:+86-0335-5035388
  • Email:wanghongyi0515@sina.com
Location:FLIP FLOP SCREEN
Briefing Of Filp Flop Screen

    post time:2014/10/31    visits:2943    

Operating principle

       This screen utilize dual-body sub-resonance principle: that is fixed screen body’s linear motion and activated floating frame vibration. They move in relatively direction. In this process, the screen panel continues expanding and contracting (800 times per minute) so achieve a high acceleration rates (up to 50 g) and prevent the screen panel openings from plugging.

1.Fixed screen body;2.Floating screen mass;3.Deck panel

Characteristic

  • The screen panel continue expanding and contracting which can produce 50g acceleration to material on panel, so it suit to screen wet sticky material. No blinding of openings.
  • It combines the advantages of banana screens with those of our flip flow screen. High material velocities on the screen deck on the feeding side and relatively low layer heights allow for considerably higher specific throughput rates. The discharge end screen has an lower inclination, causing the material to slow down. This allows the screen to filter out the remaining fine material and to achieve the desired screening efficiency.
  • Linear movement that the direct force case exciter is easy to maintenance and High responsibility.
  • EuroCMA polyurethane screen panels are a special design that can withstand 50 g’s and flexing 800 times per minute.
  • The screening machine is sat on hollow rubber spring, which causes little noise; also the rubber spring has a longer life. Screen isolator supports and screen frame are exposed to no more force than a conventional vibrating screen (even though EuroCMA machine generates up to 50 g`s vs. a conventional screen`s 5 g`s).
  • Lateral “U” Design, No wear of the side plates, No misplaced material in the underflow.
  • Screen panel are mounted without screws, de- and mounting of mats is Simple and fast.
  • EuroCMA Screen has few movable parts, so the reliability is high and has less maintenance.
  • The amplitude of floating deck is adjustable.

Technical parameters

  • Screen widths, fully usable from 1000 mm to 4300 mm
  • Screen lengths, fully usable from 4 m to 12 m
  • Descending gradient of the screens from 5 degrees to 30 degrees
  • Single deck screens, double deck screens or triple deck
  • Dry screen cut points of 3mm-50mm for coal
  • Feeding capacity up to 1500t/h depending on cut point

 

Explanation of the model

Products Photo

SINGLE BANANA DECK FLIP FLOW SCREEN UFSB36100

SINGLE BANANA DECK FLIP FLOW SCREEN UFSB4380

DOUBLE BANANA DECKS FLIP FLOW SCREEN UFDB36100

DOUBLE BANANA DECKS SCREEN WITH SINGLE FLIP FLOW DECK MAT UFDB(SF)3673

Copyright © EuroCMA All Rights Reserved.